Installation - molex UP 60 Mode D'emploi

UP 60
7.2

Installation

ATTENTION!
 Position the pneumatic Universal Crimp Machines UP 60 on a flat surface and
assure the stability of the machine. Ensure that the table or bench is stable enough
to support the machine in normal use.
 Assure an appropriate table height. The table height is depending on the position of
the operator (work in sitting or standing position), according to prEN 894-4:2004,
Table A.1.
 Assure an appropriate illumination of the working place. (EN 1837:1999 – chapter
4.2: "The general value of illumination has to be 500 lx [...]")
INFORMATION:
To reduce production noise or vibration the machine can be placed on an insulating
rubber mat.
Place the foot pedal on the floor. No other place is allowed.
ATTENTION!
 Place the tubes on the floor so that they do not cause a trip hazard.
 Do not lay the foot pedal in aisles or walk ways.
 Assure free access to the operating elements of the machine, especially the foot
pedal and the release button.
 During transport and installation of the machine wear suitable safety shoes.
INFORMATION:
To work fatigue-proof the user has to take a working position, where the machine is in
a right height position and an acceptable usage of the foot pedal is possible. The foot
pedal has to be installed in a stable position. The position of the foot pedal should be
chosen in that way, that a free access will be possible.
Page 48 / 104
TM-638018900 REV. B