molex UP 60 Mode D'emploi page 56

UP 60
- Disconnect pneumatic supply.
Remove the safety guard (4) and the cover for
-
the adapter mounting (3).
- Choose the correct die set.
Push the pin in the upper adapter half (1)
-
upwards and locate the upper die half correctly
within the retention plates.
- Release the pin and move the die half back and
forth until the spring locator audibly locates.
- Push the pin in the lower adapter half (2)
downwards and locate the lower die half
correctly within the retention plates.
Release the pin and move the die half back and
-
forth until the spring locator audibly locates.
INFORMATION:
Control the right position of the die
halves! The size of the profile should
be in line!
- Install the cover for the adapter mounting (3)
and the safety guard (4).
Page 56 / 104
TM-638018900 REV. B
1
2
3
4
Fig. 9.06
Fig. 9.07