Publicité
en-us Home Connect®
Display
Setting
-
Cooktop-based hood control
The settings are configured based on the
extractor hood model.
Restoring the factory settings
AutoChef®
You can set the temperature unit for
AutoChef® to °F or °C. The cooking zone
display will show
AutoChef®.
1
Factory setting
To go to the basic settings
Requirement: The cooktop must be switched off.
To switch on the cooktop, touch
1.
Within the next 10 seconds, touch and hold
2.
seconds.
Product information
Customer service directory
Production number
Production number 1
Production number 2
a The first four displays provide product information.
Touch
to view the individual displays.
Touch
to access the basic settings.
3.
a and light up as a presetting.
Touch
repeatedly until the desired setting
4.
appears.
Select the required setting in the settings area.
5.
Touch and hold
6.
a The settings are saved.
Discarding changes to the basic settings
Touch
.
▶
a All changes are discarded and not saved.
8.14 Power limitation
You can use this function to set the total power of the
cooktop.
The cooktop is set at the factory. You can find the
maximum power of the cooktop on the rating plate. You
can use this function to adjust the configuration to the
requirements of each electrical installation.
In order to not exceed this set value, the cooktop
automatically distributes the available power as needed
between the cooking zones that are switched on.
While this function is activated, the output of each cooking
zone may temporarily fall below the nominal value. If a
cooking zone is switched on and the power limit is
reached, the required power level and the maximum
18
or
when you activate
.
Display
for 4 seconds.
Value
- Individual settings
- Factory settings.
- °C
- °F
1
available power level flash on the power level display. The
appliance regulates and selects the highest power level
automatically.
You can find out how to do this in the "Basic settings"
section → Page 17
for 4
9 Home Connect®
Home Connect®
This appliance is network-capable. Connecting your
Home Connect®
appliance to a mobile device lets you control its functions
via the Home Connect® app, adjust its basic settings and
monitor its operating status.
The Home Connect® services are not available in every
country. The availability of the Home Connect® function
depends on the availability of Home Connect® services in
your country. You can find information on this at:
www.home-connect.com.
The Home Connect® app guides you through the entire
registration process. Follow the instructions in the
Home Connect® app to implement the settings.
Tip: Follow the instructions in the Home Connect® app as
well.
Notes
¡ Also note the safety information in this instruction
manual and ensure that it is also observed when
operating the appliance using the Home Connect® app.
¡ Operating the appliance on the appliance itself always
takes priority. It is not possible to operate the appliance
using the Home Connect® app during this time.
¡ In networked standby mode, the appliance requires a
maximum of 2 watts.
¡ Cooktops are not designed to be left unattended.
Always monitor the cooking process.
9.1 Setting up the Home Connect® app
Install the Home Connect® app on your mobile device.
1.
Start the Home Connect® app and set up access for
2.
Home Connect®.
The Home Connect® app guides you through the entire
registration process.
1
.
Publicité
