Stihl MSA 160 T Notice D'emploi page 38

English
STIHL cutting attachments complying
with CSA Standard Z 62.3:
Rollomatic E Mini 1/4" Picco guide bars
Cutting length: 25, 30 cm
Pitch: 1/4" P (6.35 mm)
Groove width: 1.1 mm
Nose sprocket: 8-tooth
1/4" Picco chain
Picco Micro 3 (71 PM3) Type 3670
Pitch: 1/4" P (6.35 mm)
Drive link gauge: 1.1 mm
Chain sprocket
7-tooth for 1/4" P
Max. chain velocity to
ISO 11681:
As a rule, the mean chain velocity in
operation is about 20% lower than the
maximum chain velocity in accordance
with ISO 11681. Contact your STIHL
servicing dealer for advice on personal
protective equipment.
Transporting
STIHL batteries comply with the
requirements laid down in UN-Manual
ST/SG/AC.10/11/Rev.5/Part III,
Subsection 38.3.
No further condition have to be fulfilled
by the user to transport STIHL batteries
by road to the power's tool operating
site.
Country-specific regulations must be
observed for transport by air or sea.
36
All manuals and user guides at all-guides.com
For further notes on transportation see
www.stihl.com/safety-data-sheets
EMC Compliance Statement for power
tool and charger
This Class B digital apparatus complies
with Canadian ICES-003.
11.5 m/s
Special Accessories
Safety glasses
–
STIHL battery
–
STIHL charger
–
STIHL battery belt
–
Bag for STIHL battery belt
–
Harness for STIHL battery belt
–
File holder with round file
–
File gauge
–
Check gauges
–
STIHL filling system for chain oil –
–
prevents spillage or overfilling
during filling
Battery compartment cover
–
Ask your STIHL servicing dealer for
current information about this and other
special accessories.
MSA 160 T