voestalpine Bohler Welding URANOS 2000 SMC Mode D'emploi page 34

ALARM CODES
6.1 Carry out the following periodic checks on the power source
EN 6.1.1 System
connections and all the connection cables.
6.1.2 For the maintenance or replacement of torch components, electrode holders and/or
earth cables:
Check the temperature of the component and make sure that they are not overheated.
Always use gloves in compliance with the safety standards.
Use suitable wrenches and tools.
6.2 Responsibility
Failure to carry out the above maintenance will invalidate all warranties and exempt the manufacturer from any
liability. The manufacturer disclaims any responsibility if the user fails to follow these instructions. For any doubts
and/or problems do not hesitate to contact your nearest customer service centre.
7. ALARM CODES
ALARM
Activation of an alarm or the passing of any critical limit causes a visual signal to appear on the control panel and
the immediate shut-down of welding operations.
CAUTION
Exceeding a guard limit causes a visual signal on the control panel but allows the welding operations to continue.
All the alarms and all the guard limits relating to the system are listed below.
Overtemperature
E01
Wire feeder motor power supply fault
E07
Power module overcurrent (Inverter)
E10
System configuration error
E19
Data loss
E21
Overvoltage
E41
Overtemperature
E03
Blocked motor
E08
Communication error
E13
Memory fault
E20
System power supply fault
E39
Undervoltage
E42
34