voestalpine Bohler Welding URANOS 2000 SMC Mode D'emploi page 14

INSTALLATION
EN
Connect the gas hose from the cylinder to the rear gas connection. Adjust the gas flow from 5 to 15 l/min.
2.4.3 Connection for MIG/MAG welding
Connect the power cable to the positive pole of the terminal strip to change polarity (see"Changing the welding polarity").
Connect the earth clamp to the negative socket (-) of the power source. Insert the plug and turn clockwise until all parts are
secured.
Connect the MIG/MAG torch to the central adapter, ensuring that the fastening ring is fully tightened.
Connect the gas hose from the cylinder to the rear gas connection. Adjust the gas flow from 5 to 15 l/min.
Gas tube
1
Rear gas connection
2
Power cable
1
Positive power socket (+)
2
Earth clamp connector
3
Negative power socket (-)
4
MIG/MAG torch
5
6
Gas tube
1
Rear gas connection
2
14