voestalpine Bohler Welding URANOS 2000 SMC Mode D'emploi page 24

SETUP
Program cancellation
EN
5. SETUP
5.1 Parameter set up and setting
Permits set-up and adjustment of a series of additional parameters for improved and more accurate control of the welding
system.
The parameters present at set up are organised in relation to the welding process selected and have a numerical code.
Entry to set up
Selection and adjustment of the required parameter
Rotate the encoder until you display the numerical code for the required parameter.
If the encoder key is pressed at this point, the value set for the parameter selected can be displayed and adjusted.
Exit from set up
To quit the "adjustment" section, press the encoder again.
To exit the set-up, go to parameter "0" (save and quit) and press encoder key.
To save the change and exit the set up, press the key:
5.1.1 List of set up parameters (MMA)
Save and Exit
0
Allows you to save the changes and exit the set up.
Reset
1
Allows you to reset all the parameters to the default values.
Select the required program by rotating the encoder.
The entry will be confirmed by the writing 0 on the display
.
.
24
.
.
.
.