voestalpine Bohler Welding URANOS 2000 SMC Mode D'emploi page 29

Buzzer tone
552
Permits adjustment of the buzzer tone.
Minimum
0/off
Current reading
751
Allow the real value of the welding current to be displayed.
Voltage reading
752
Allows the real value of the welding voltage to be displayed.
853
Value
on
off
5.1.3 List of set up parameters (MIG/MAG)
Save and Exit
0
Allows you to save the changes and exit the set up.
Reset
1
Allows you to reset all the parameters to the default values.
Welding programs
2
Allows selection of the manual MIG (
welded.
Refer to section "Front control panel".
Wire speed
3
Allows the regulation of the wire feed rate.
Minimum
0.5 m/min
Current
4
Allows the regulation of the welding current.
Minimum
3 A
Workpiece thickness
5
Allows the thickness of the part being welded to be set.
Corner bead "a"
6
Lets you set bead depth in a corner joint.
Maximum Default
10 10
Default
X
- power always active
) or synergic MIG (
Maximum Default
22.0 m/min -
Maximum
Imax
29
SETUP
EN