voestalpine Bohler Welding URANOS 2000 SMC Mode D'emploi page 28

SETUP
Final current
17
Permits adjustment of the final current.
EN
Minimum
3 A
Final current time
19
Makes it possible to set the time for which the final current is maintained.
Minimum
0/off
Post-gas
20
Minimum
0/off
Spot welding
204
Allows you to enable the "spot welding" process and establish the welding time.
Allows the timing of the welding process.
Minimum
0/off
Restart
205
Allows the activation of the restart function.
Allows the immediate extinguishing of the arc during the down slope or the restarting of the welding cycle.
Value
0/off
1/on
2/of1
Easy joining
206
Allows striking of the arc in pulsed current and timing of the function before the automatic reinstatement of the
pre-set welding conditions.
Allows greater speed and accuracy during tack welding operations on the parts
Minimum
0.1 s
Microtime spot welding
208
Allows you to enable the "microtime spot welding" process.
Allows the timing of the welding process.
Minimum
0.01 s
500
Allows the selection of the required graphic interface.
Allows access to the higher set-up levels.
Refer to section "Interface personalisation (Set up 500)"
Value
USER
SERV
vaBW
Lock/unlock
551
Allows the locking of the panel controls and the insertion of a protection code.
Refer to section "Lock/unlock (Set up 551)".
Maximum Default
Imax 10 A
Maximum Default
99.9 s 0/off
Maximum Default
99.9 s syn
Maximum Default
99.9 s 0/off
Default Callback function
- off
X on
- off
Maximum Default
25.0 s 0/off
Maximum Default
1.00 s 0/off
Selected level
User
Service
vaBW
Minimum Maximum
1 % 200 %
28
Default
50 %