voestalpine Bohler Welding URANOS 2000 SMC Mode D'emploi page 30

SETUP
Voltage - Arc length
7
Allows the regulation of the arc voltage.
EN
Allows regulation of the arc length during welding.
High voltage = long arc
Low voltage = short arc
Synergic mode
Minimum
-5.0
Manual mode
Minimum
5.0 V
Pre-gas
10
Allows you to set and adjust the gas flow prior to striking of the arc.
Permits filling of the torch with gas and preparation of the environment for welding.
Minimum
0/off
11
Permits adjustment of the wire feed speed in the phases prior to arc striking.
Minimum
10 %
Motor slope
12
Allows you to set a gradual transition between the sparking wire speed and the welding wire speed.
Minimum
0/off
Burn back
15
Permits adjustment of the wire burn time, preventing sticking at the end of welding.
Permits adjustment of the length. Permits adjustment of the length of the piece of wire outside the torch.
Minimum
-2.00
Post-gas
16
Minimum
0/off
Initial increment
25
Allows regulation of the wire speed value during the first "crater-filler" welding phase.
Makes it possible to increase the energy supplied to the part during the phase when the material (still cold) requires
more heat in order to melt evenly.
Minimum
20 %
Crater filler
26
Allows regulation of the wire speed value during the weld closing phase.
Makes it possible to reduce the energy supplied to the part during the phase when the material is already very hot,
thus reducing the risk of unwanted deformations.
Minimum
20 %
Maximum Default
+5.0 0/syn
Maximum Default
55.5 V 5.0 V
Maximum Default
99.9 s 0.1 s
Maximum Default
100 % 50 %
Maximum Default
1.0 s 0/off
Maximum Default
+2.00 0/syn
Maximum Default
99.9 s 2.0 s
Maximum Default
200 % 120 %
Maximum Default
200 % 80 %
30