Parkside PDFP 500 C3 Traduction Des Instructions D'origine page 9

Adjusting the airflow
NOTE
► We recommend starting with the airflow set
to maximum . To do this, open the airflow
regulator to maximum as described below
in the section "Increasing the airflow" .
Increasing the airflow:
NOTE
► Increasing the airflow is generally advisable
if the dispersion is too coarse .
♦ Turn the airflow control
Decreasing the airflow:
NOTE
► Decreasing the airflow is generally advisable
if the paint mist is too strong .
♦ Turn the airflow control
Maintenance and cleaning
WARNING! RISK OF INJURY!
Disconnect the appliance from the
compressed air supply.
NOTE
► Thorough cleaning after every use is very
important for safety and operation . Other-
wise, the needle could get blocked and
proper operation of the appliance cannot
be guaranteed .
■ Wear suitable gloves when cleaning .
■ Do not use any hydrocarbon-based solvents
like benzene, ethyl chloride, etc ., as these could
trigger chemical reactions with some of the
materials in the paint spray gun . This can lead
to dangerous reactions .
■ 6 │ GB │ IE │ NI
anticlockwise .
clockwise .
CAUTION!
► Never immerse the paint spray gun com-
pletely in solvent .
■ After every use, squirt thinners (only outside
– risk of explosion!) or water through the
appliance .
♦ To clean the housing, the nozzle head
spray holes inside it, use the supplied cleaning
brush or a cloth . Never use petrol, solvents or
cleansers which can damage plastic .
♦ First, unscrew the stroke limiter screw
it in an anticlockwise
♦ Remove the spring
♦ Remove the needle
♦ Clean the needle
(see fig . B) .
♦ Replace the needle
♦ Push the spring onto the end of the needle
♦ Screw the stroke limiter screw
it clockwise .
♦ Screw the flow cup
spray gun .
♦ Remove the filter
clean it with the cleaning brush .
♦ Also clean the screw thread
using the cleaning brush (see fig . D) .
♦ Replay the filter in the spray gun (see fig . C)
and screw the flow cup
onto it .
♦ For rust protection purposes, you can spray a
little sewing machine oil through the spray gun
after cleaning .
♦ Oil all moving parts from time to time .
♦ After cleaning the needle, the thread and seal
must be lightly greased with a suitable lubricant .
♦ Do not use any silicon-based lubricants .
♦ Store compressed-air appliances only in dry
rooms .
and the
by turning
direction .
.
using pliers (see fig . A) .
carefully with the brush
in the paint spray gun .
tight by turning
anticlockwise off the
as shown in fig . C and
of the flow cup
clockwise firmly
PDFP 500 C3
.