Parkside PDFP 500 C3 Traduction Des Instructions D'origine page 8

♦ Connect the compressed air hose with the
quick-action coupling to the compressed-air
connection on the appliance . The connection
locks automatically .
♦ Set the working pressure on the filter pressure
reducer of the compressed air source to 3 bar .
Preparing the surface
♦ Carefully cover a large area around the spray
surface . Any surface that is not masked could
become contaminated .
♦ Ensure that the spray surface is clean, dry and
free of grease .
♦ Polished surfaces should be lightly sanded and
the sanding dust removed .
Switching the appliance on/off
Working methods:
♦ Fit the filter in the gun (see fig . C) .
♦ The vent must remain open while working .
♦ When thinning, ensure that the spray material
and the thinners are suitable for each other .
Using an unsuitable thinner can lead to the
formation of lumps which, in turn, can block the
spray gun .
♦ Screw the flow cup
gun .
♦ Fill the flow cup
close the lid .
♦ Hold the spray gun at a constant distance from
the object . The ideal spraying distance is ap-
prox . 15 cm .
♦ Work out the right settings by carrying out a test .
♦ Do not switch the appliance on/off over the
spray surface, rather start/end the spraying
process approx . 10 cm from the spray surface .
Switching on:
♦ To switch on, pull the trigger
pressed in .
Switching off:
♦ To stop working, simply release the trigger
PDFP 500 C3
clockwise onto the spray
with spray material and
and keep it
Setting the paint jet pattern
The appliance has two settings: round jet and
broad jet .
Round jet
Setting the round jet:
■ Use the round jet for small surfaces, corners
and edges .
♦ Turn the control
Setting the broad jet:
■ You can use the broad jet vertically or horizon-
tally for larger surfaces .
♦ Turn the control
The nozzle head
position between the horizontal and the vertical .
Adjusting the paint flow
NOTE
► The front locking bolt is designed to limit the
adjustment range of the stroke limiter screw
Increasing the paint flow:
♦ Turn the stroke limiter screw
Decreasing the paint flow:
♦ Turn the stroke limiter screw
.
Broad jet
clockwise .
anticlockwise .
can be turned into any
anticlockwise .
clockwise .
GB │ IE │ NI │
.
5 ■