Parkside PDFP 500 C3 Traduction Des Instructions D'origine page 7

Safety instructions for fine spray
systems
■ Keep your work area clean, well lit and free
of paint and solvents, cloths and other inflam-
mable materials. Possible risk of spontaneous
combustion . Have a fully-functioning fire extin-
guisher available at all times .
■ Ensure adequate ventilation in the spray zone
and sufficient fresh air in the entire room.
Evaporation of flammable solvents will cause
an explosive environment .
■ Do not spray or clean with materials whose
ignition point is lower than 21°C. Use mater-
ials based on water, non-volatile hydrocarbons
or similar materials. The evaporation of volatile
solvents will cause an explosive environment .
■ Do not spray near ignition sources such as
static electric sparks, open flames, ignition
flames, hot items, motors, cigarettes and
sparks caused by plugging in/unplugging
power cables or by operating switches. These
ignition sources could cause a fire to ignite in
the environment .
■ Do not spray any material if you do not know
whether it is potentially dangerous. Unknown
materials could cause dangerous conditions .
■
Wear additional personal protective equip-
ment such as suitable gloves and a protective
mask/respirator when spraying or handling
chemicals. Wearing appropriate protective
equipment for the conditions reduces your
exposure to dangerous substances .
■ Do not spray yourself, other people or animals.
Keep your hands and other body parts out
of the spray jet. If the spray jet pierces the
skin, seek medical assistance immediately . The
sprayed material can even penetrate through a
glove and into the skin and thus into your body .
■
Do not treat such a penetration injury like a
normal cut. A high-pressure jet can inject toxic
materials into the body and cause serious in-
juries. In the event of a chemical penetration of
the skin, seek medical assistance immediately .
■ 4 │ GB │ IE │ NI
■ Be aware of the potential hazards of the
sprayed material. Take note of the markings
on the container and the manufacturer's infor-
mation on the sprayed material, including the
instruction to use personal protective equip-
ment. The manufacturer's instructions are to
be followed to reduce the risk of fire or injuries
caused by poisons, carcinogens, etc .
■
Never spray without the nozzle head fitted.
Using a special nozzle with the appropriate
nozzle head reduces the likelihood of high-
pressure jets piercing the skin and injecting
poisons into your body .
Operation
HVLP properties
This appliance has a HVLP system (high volume,
low pressure) . This ensures increased material
(paint) application and lower consumption .
IMPORTANT: Do not exceed the maximum working
pressure of 3 bar .
Connecting the device
■ The product may only be operated using
cleaned, condensate- and oil-free compressed
air and may not exceed the maximum operating
pressure of 3 bar on the appliance .
■ To ensure that you can regulate the air pressure,
the compressed air source should be equipped
with a (filter) pressure reducer .
You will need a flexible compressed air hose
with a quick-disconnect coupling and a suitable
compressed air source to operate this appliance .
Follow all the operating and safety instructions for
the compressed air source and any special instruc-
tions regarding paint preparation .
NOTE
► Take note of the correct working pressure .
Excessively high pressure leads to strong
dispersion and overly-rapid liquid evapora-
tion . The surfaces become rough and develop
poor adhesion properties . If, however, the
working pressure is too low, the paint will not
be adequately dispersed . This leads to wavy
surfaces and droplets .
PDFP 500 C3