Alva NEO PRO Mode D'emploi page 6

2/ TRANSMIT MODE
2.1/ TURNING ON THE DEVICE
The device is off when the ON/OFF
switch is in the "OFF" position. To
turn on the device, turn the ON/
OFF switch 90°; the switch should
point to "ON". The switch is prop-
erly locked when it points towards
"ON" and you have heard it click into
place.
When the device turns on, it automat-
ically checks that all main functions
are working properly. Verify that the
auto-test runs correctly and pay close
attention to any error messages that
display when turning on your device.
10
The device then displays the software
version installed and remaining bat-
tery life. We recommend that you re-
place the batteries as soon as it drops
below 50%. Holding down the marking
button in transmit mode will allow you
to check battery life left at any time.
Once the start-up phase is complete,
the device prompts the user to conduct
a GROUP CHECK (see paragraph 3.1.
GROUP AND FREQUENCY TEST) and
then automatically switches to trans-
mit mode. A blinking arrow in the up-
per middle of the screen confirms that
your transceiver is in transmit mode.
2.2/ WEARING THE DEVICE
Make sure that the carabiner on the elastic attachment
%
lanyard is connected to the holster's waist belt (2 posi-
tions, left or right), position the device in the holster with
the screen facing out,
and then buckle the
holster closed. The
NEO PRO should al-
ways be worn over a
base layer and as close
to your body as possi-
ble.
%
2.3/ TURNING OFF THE DEVICE
To turn off the device, turn the ON/OFF
switch 90°. The switch should be paral-
lel to the "OFF" hash mark. The switch is
properly locked when it is parallel to the
"OFF" hash mark and you have heard it
click into place.
3/ SEARCH MODE
In the event of an avalanche, to switch from search to
transmit mode, take the device out of your pocket or hol-
ster and push the "SEND/SEARCH" selector switch into
the "SEARCH" position.
3.1/ GROUP AND FREQUENCY CHECK
Before starting your outing, check to make sure that
everyone's device is in transmit mode and working prop-
erly. The group leader should switch their device into
GROUP CHECK mode to check the devices of the other
EN
11