Publicité
EASY 6000 PRO– Issue 00
11.6 ADJUSTING HATCH OPENING
After changing the dimensions of the compartments, the opening of the pick-up hatches must also be
changed. To perform this operation correctly, follow the instructions given below:
1) Always work with the power supply disconnected after turning the main switch OFF;
2) Move the retainer block into the required position. The block is secured with a screw.
The following figure shows the relative to stop positions for the various configurations with 4, 6-8-12-16-24-
48 compartments.
11.7 ADJUSTING BELT TENSION
FAS INTERNATIONAL S.r.l. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
If the pick-up hatches do not close correctly, it
may be necessary to check and tension the
toothed belt that drives the hatches.
To perform this operation correctly, follow the
instructions given below:
1) Open the main door of the vending machine
and turn off the electricity supply from the main
switch;
2) Remove the belt tensioner cotter pin, pos. -A-;
3) Referring to the figure, move the cotter pin by
one hole in the required direction: + tension or -
tension;
4) Perform opening-closing tests on the hatches
to verify correct adjustment.
49
E
N
G
L
I
S
H
Publicité
