Publicité
EASY 6000 PRO– Issue 00
6.3
INSTALLATION
The vending machine must be installed in a place that is - or can be - aired (floor, intermediate floor) and that
can withstand its weight.
The unit cannot be installed outdoors, must not be exposed to direct sunlight or installed
where jets of water may be used. The unit can be installed in a place with ambient
temperature ranging between 3°C and 32°C.
Check that the power of the whole electrical system is adequate for the maximum power of the machine (see
plate). When in doubt, contact a qualified technician. Such personnel should also verify that the section of
the plant cables are suitable for the power absorbed by the vending machine.
GREEN AND YELLOW - EARTH ---- BLUE - NEUTRAL ---- BROWN - PHASE
As the colours of the wires in the unit cable may not correspond to the coloured markings
on the terminals in your plug, proceed as follows:
Connect the GREEN and YELLOW wire to the terminal which is marked E, bears the
earth symbol, or is coloured either GREEN or GREEN and YELLOW. Connect the BLUE
wire to the terminal which is marked N or is coloured BLACK or BLUE. Connect the
BROWN wire to the terminal which is marked L or is coloured RED or BROWN.
The manufacturer cannot be held liable for damages resulting from failure to
observe the above precautions.
•
Once the connections have been made, the vending machine must be placed near a wall so that its back
has a minimum distance of 7 cm from the wall in order to allow for regular ventilation.
•
After having positioned the machine, adjust the four adjustable feet so that the machine is perfectly
horizontal; all the feet should touch the floor.
•
Mount the front leg cover.
•
Check both the front leg cover and the mesh screens behind and under the refrigeration unit to ensure
they are always clean and not blocked in any way.
FAS INTERNATIONAL S.r.l. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
The following guidelines apply only to the United Kingdom.
The cables are colour coded as follows:
Description of connections:
1 "Schuko" German-type plug
2 Differential magneto thermal switch
15
E
N
G
L
I
S
H
Publicité
