Publicité
46
E
11.1 REMOVING THE DISCS
N
G
L
To remove the disc from the drawer, proceed as follows:
I
Open the main door of the vending machine and turn off the electricity supply from the main switch;
S
H
11.2 REPLACING THE DISC CONTROL BOARD
FAS INTERNATIONAL S.r.l. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
11
Disconnect the power supply by turning off the main switch and then unplug the
power supply before starting operations.
ADJUSTMENTS
Pull out the drawer by overcoming the
resistance exerted by the positioning
spring (pull gently).
Pull the drawer until it reaches the stop.
Remove all products from the disc (if
any are present).
Take hold of the disc and pull it out of its
seat.
If the drawer also has to be removed:
disconnect the connector "D" on the left
side inside the body, lift the catches "C"
on the sides and remove the drawer.
Repositioning the disk on the drawer:
first of all, couple the disc's teeth on the
gearmotor pulley "A", then insert the
disc's centring pin in its seat "B" in the
drawer.
EASY 6000 PRO– Issue 00
Publicité
