Publicité
EASY 6000 PRO– Issue 00
8.2.7
AUDIT
The control board is equipped with an RS232 socket. The I/O connector is a 9-pin male that uses the
following pins:
- Pin 2 VMC Tx
- Pin 3 VMC Rx
Enable Conventional Audit: enables the audit via a third party terminal/modem (FAScloud is not used)
Enable sending events: ticking this box enables sending of all events (door closed, errors, etc.) to the
conventional audit (otherwise only EVA DTS data will be managed)
Audit protocol: by selecting
outside world via the infra-red interface 082925 (IRDA interface) or through physical connection on the 9-pin
connector, according to the specifications of the EVA-DTS protocol, vers. 6.0.
If the command is set DEX UCS, the machine communicates with the outside world with the DEX-UCS
protocol.
Connection port: the machine offers the choice of the type of connection: Infra-red interface (IRDA
OUTPUT) or cable interface on the 9-pin connector on the board (RS232 OUTPUT).
Transmission speed: you are offered the choice of transmission speed, which must be consistent with the
setting of the 082925 board in the case of infra-red connection (see related instructions). The selection is
made by scrolling through the various speed options from the drop-down menu
Peripheral address: the machine prompts you to enter the address of the peripheral: enter the desired
value
Negotiated speed: enables the possibility of speed negotiation between the machine and the terminal
(option valid only for cable connection)
Asset number: this is an 8-digit machine identification numeric code. This will then be entered in the Audit
file for machine identification
Disable sending single sales event: ticking the box blocks sending the event generated by each individual
sale (used to avoid managing very large amounts of data)
Disable sending temperature event: ticking the box blocks sending the event generated by reading the
internal temperature probe of the D.A. every 15 minutes (used to avoid managing very large amounts of
data)
FAS INTERNATIONAL S.r.l. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
- Pin 5 Ground -Pin 7 CTS
EVA-DTS DDCMP from the menu the
machine communicates with the
33
E
N
G
L
I
S
H
Publicité
