Publicité
22
8.2.3
E
N
G
Quit and return to previous screen
L
I
S
Used to set the payment system operating mode
H
Used to set various parameters relating to the payment system depending on its operating mode
8.2.3.1
Payment system: it is possible to choose the type and mode of coin mechanism operation. The parameter
can assume the following values:
•
EXECUTIVE with prices managed in the machine
•
EXECUTIVE PRICE HOLDING (i.e. prices programmed in the coin mechanism); in this case, prices
programmed using the
mechanism. Alternatively you can set the "Price-Display" parameter. If enabled, the machine will
exclusively use the price information received from the payment system
•
BDV
•
MDB
Single/multi-sale: it is possible to choose whether the vending machine operates in single-sale mode and
thereby gives change in cash mode. If this is not possible, the sum is added to the amount totalled due to
overpricing. Conversely, if the vending machine operates in multi-sale mode, the amount in excess of cost
after the sale is displayed once again and can be recovered by simply pressing the "change" button or used
for a new selection.
Machine blocked if payment systems are off-line: it is possible to choose whether to block the vending
machine if the payment system is out of service
Enable change-giver motor: enables the change-giver motor.
Enable coin insertion sensor:
it is possible to enable the presence of the microswitch involved in coin insertion.
Change-giver inactivity time: allows setting of the time interval between one change-giver motor cycle and
the next during the vending machine idle time. The single cycle is programmable between a minimum time of
2 minutes and a maximum of 250 minutes.
FAS INTERNATIONAL S.r.l. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
PAYMENT SYSTEMS
PROTOCOL
Prices icon must be the same as those programmed in the coin
EASY 6000 PRO– Issue 00
Publicité
