Barbecook SIESTA 310 BLACK EDITION Mode D'emploi page 27

coupling to the gas tube on the appliance.
The appliance is supplied with two different couplings
intended for use in different countries.
Country
BE, CH, CZ, DK, ES,
FI, GB, IE, IT, PT, SI
FR
If your country is not listed in the table, use the
coupling that meets the standards that apply in your
country.
B
6.3.1 Coupling A
You require a 19 mm wrench and a Phillips screwdriver.
1. Screw the coupling onto the gas tube on the appliance (A)
and tighten it with a 19 mm wrench (B).
A
2. Slide the hose over the coupling (C) and tighten the
C
clamping ring with a Phillips screwdriver (D).
TIP: Apply a small amount of dish soap to the coupling
and heat the end of the gas hose with a hair drier so that it
slides smoothly over the coupling.
27
Coupling
Coupling A
Coupling B
A
B
D
www.barbecook.com
C
6.3.2 Coupling B
You require a 22 mm wrench and an adjustable wrench.
1. Screw the coupling onto the gas tube on the appliance (A)
and tighten it with a 22 mm wrench (B).
A
A
2. Screw the gas hose onto the coupling (C) and secure it
C
with two wrenches. Hold the coupling firm with one 22 mm
wrench and tighten the hose with an adjustable wrench.
C
6.4. Connect the hose and gas bottle to the regulator.
You will require a Phillips screwdriver and/or an adjustable
wrench
depending on the type of regulator that you are using.
1. Connect the hose to the pressure regulator. Proceed as
follows:
• If the hose is fitted with a clamping ring, slide the hose over
the regulator and tighten the clamping ring with a Phillip
screwdriver (A).
• If the hose is fitted with a nut, screw the hose onto the
regulator and tighten the nut with and adjustable wrench
(B).
D
B
B
D
D