Publicité
NOTE
The information contained in this Manual is designed to assist you in the safe maintenance of the Nailer.
NEVER attempt any maintenance on the nailer unless you have first read and understood all safety instructions
contained in this manual.
Some illustrations in this Manual may show details or attachments that differ from those on your own Nailer.
MAINTENANCE AND INSPECTION
<Nailer>
Read section titled "SAFETY" (pages 2–9).
WARNING
Remove battery and all remaining fasteners from
Nailer when:
1) doing maintenance and inspection; and
2) clearing a jam.
1. Everyday maintenance
○ Blow clean the magazine and feeder mechanism
daily, to prevent jamming.
○ Blow clean the push lever daily, to keep the push
lever working properly and to promote operator safety
and efficient Nailer operation.
WARNING
● Wear safety glasses with side shields while
performing this work, to avoid risk of eye injury.
● Do not use oil, lubricant, or solvents when
cleaning the Nailer body.
<Inspecting the push lever>
Clean the push lever sliding part.
<Inspecting the nail feeder>
Clean the knob sliding part.
Open the nail guide and remove dust.
WARNING
Check that the main nail stopper and sub nail
stopper slide smoothly by pushing them with
finger. If not smooth, nails can be driven at an
irregular angle and hurt someone.
NV1845DA_C99751761_409_NA
Stylesheet: NA Version: 2024.7.4
MAINTENANCE
Main nail stopper
<Inspecting the magazine>
Clean the magazine. Remove dust and wooden chips
which may have accumulated in the magazine.
2. Check for dust (other than on metal parts)
Dust may be removed with a soft cloth or a cloth
dampened with soapy water.
Do not use bleach, chlorine, gasoline or thinner, for
they may damage the plastics.
3. Inspection of terminals (Tool and battery)
Check to make sure that swarf and dust have not
collected on the terminals.
On occasion check prior, during and after operation.
CAUTION
Remove any swarf or dust which may have
collected on the terminals.
Failure to do so may result in malfunction.
4. Check the Screws
Loose screws are dangerous. Regularly inspect them
and make sure they are tight.
CAUTION
Using this power tool with loosened screws is
extremely dangerous.
Knob
Nail guide
Sub nail stopper
English
Feeder
23
2024/07/31 17:15:40
Publicité
