NOTE
○ If all warnings and instructions are followed, safe
operation is possible with all two systems: FULL
SEQUENTIAL ACTUATION MECHANISM,
CONTACT ACTUATION MECHANISM.
○ Always handle nails and package carefully. If nails are
dropped, collating bond may be broken, which will
cause mis-feeding and jamming.
○ After nailing:
1. remove battery from the Nailer;
2. remove all nails from the Nailer;
ADJUSTING THE NAILING DEPTH
To assure that each nail penetrates to the same depth, be
sure that the Nailer is always held firmly against the
workpiece.
If nails are driven too deep or shallow into the workpiece,
adjust the nailing in the following order.
(1) Remove the battery from the Nailer.
(2) If nails are driven too deep, turn the adjuster to the
shallow side.
Adjustments are in half-turn increments.
If nails are driven too shallow, turn the adjuster to the
deep side.
(2)
Too Deep
(2)
Too Shallow
(3) Stop turning the adjuster when a suitable position is
reached for a nailing test.
(4) Connect the battery to the Nailer.
ALWAYS WEAR SAFETY GLASSES.
Perform a nailing test.
(5) Remove the battery from the Nailer.
(6) Choose a suitable position for adjuster.
USING THE HOOK
WARNING
● When using the hook, turn off the power switch
(green light "OFF").
NV1845DA_C99751761_409_NA
Stylesheet: NA Version: 2024.7.4
Turn Adjuster
Flush
Turn Adjuster
Flush
● Pay sufficient attention so that the main
equipment does not fall.
If the tool falls, there is a risk of accident.
Hook can be installed on the left or right side.
(1) Securely hold the main unit and remove the M5 bolts
using the allen wrench.
Hook plate
(2) Remove the hook and hook plate.
(3) Install the hook on the other side and securely fasten
with M5 bolt.
USING THE VINYL SIDING ADAPTER
WARNING
When attaching or detaching the adapter, be
sure to remove your finger from the trigger and
remove all remaining fasteners and the battery
from the nailer.
When fastening vinyl siding, attach the adapter. The
adapter allows driving the nails to remain protruding the
proper amount.
(1) Remove all remaining fasteners and battery from
nailer.
(2) Put the adapter to the toe of the push lever.
English
M5 bolt
Allen wrench
Hook
21
2024/07/31 17:15:40