Publicité
4. Remove the finger from the trigger and press the
push lever against the workpiece.
–
THE NAILER MUST NOT OPERATE.
Do not pull trigger
Depress Push lever
5. Separate the push lever from the workpiece.
Next, point the nailer downward, pull the trigger and
then wait in that position for 5 seconds or longer.
–
THE NAILER MUST NOT OPERATE.
Pull the trigger
6.
(1) Without touching the trigger, depress the push lever
against the workpiece.
Next, pull the trigger.
–
THE NAILER MUST OPERATE.
(2) Hold the trigger back and depress the push lever
against the workpiece again.
–
THE NAILER MUST NOT OPERATE.
(3) Separate the finger from the trigger. Next, (1) is
operated again.
–
THE NAILER MUST OPERATE.
NV1845DA_C99751761_409_NA
Stylesheet: NA Version: 2024.7.4
7. Separate the push lever from the workpiece, pull the
trigger.
Depress the push lever against the workpiece within
2 seconds.
–
THE NAILER MUST NOT OPERATE.
8. Set the nailing operation indicator blinking ON mode.
(CONTACT ACTUATION MECHANISM)
Push the nailing operation switch once, make sure
that the indicator is blinking Blue.
Separate the push lever from the workpiece, pull the
trigger.
Depress the push lever against the workpiece within
2 seconds.
–
THE NAILER MUST OPERATE.
9. If no abnormal operation is observed, you may load
nails in the Nailer.
Drive nails into the workpiece that is the same type to
be used in the actual application.
–
THE NAILER MUST OPERATE PROPERLY.
LOADING NAILS
WARNING
When loading nails into Nailer,
1) remove battery from the nailer;
2) do not pull trigger;
3) do not depress push lever; and
4) keep nailer pointed downward.
1. Press the knob down and swing the nail guide open.
And open the magazine cover.
1
2
Knob
Nail guide
2. Adjust the position of the nail holder according to the
nail length.
The nail will not feed smoothly if the nail holder is not
correctly adjusted.
(1) Turn the nail holder about 90 degrees
counterclockwise.
English
3
Magazine cover
17
2024/07/31 17:15:40
Publicité
