Publicité
DANGER
Operators and others in work area MUST wear
safety glasses with side shields which conforms
to ANSI Z87.1 specifications.
WARNING
● NEVER point tool at yourself or others in work
area.
● Keep fingers AWAY from trigger when not
driving nails to avoid accidental firing.
● Do not use the electrical cord if damaged. Have it
repaired immediately.
● Choice of triggering method is important. Please
read and understand "METHODS OF
OPERATION" found below.
● Before starting work, check the nailing operation
switching device. This metabo HPT nailer
includes a nailing operation switching device.
Before starting work, make sure that the
switching device is properly set. If the switching
device is not set properly, the nailer will not
operate correctly.
● Never place your face, hands or feet near firing
head when using.
● Do not drive nails on top of other nails or with
Nailer at too steep of an angle; nails can ricochet
and hurt someone.
● Do not drive nails into thin boards or near
corners and edges of workpiece. Nails can be
driven through or away from workpiece and hit
someone.
● Never drive nails from both sides of a wall at the
same time. Nails can be driven into and through
the wall and hit a person on the opposite side.
● Never use Nailer which is defective or operating
abnormally.
● Do not use Nailer as hammer.
● Remove all remaining fasteners and battery from
nailer when:
1) doing maintenance and inspection;
2) checking proper operation of push lever and
trigger;
3) attaching or removing the adapter;
4) cleaning a jam;
5) it is not in use;
6) leaving work area;
7) moving it to another location; and
NV1845DA_C99751761_409_NA
Stylesheet: NA Version: 2024.7.4
8) handing it to another person.
● Remove battery from Nailer when:
1) loading nails;
2) turning the adjuster.
This metabo HPT nailer is equipped with a nailer operation
switching device.
Use FULL SEQUENTIAL ACTUATION MECHANISM or
CONTACT ACTUATION MECHANISM in accordance
with the work to be performed.
Explanation of the various nailing operation
○ FULL SEQUENTIAL ACTUATION MECHANISM:
First, press the push lever against the wood; next, pull
the trigger to drive the nail.
Follow the same sequence to continue driving nails.
After nailing once, nailing will not be possible again
until remove finger from the trigger and lift the tool off
the wood surface completely.
○ CONTACT ACTUATION MECHANISM:
1. Pull the trigger.
2. Press the push lever against the wood to drive the
nail.
3. If the trigger is held back, a nail will be driven each
time the push lever is pressed against the wood.
NOTE
Be careful that the final nail can be dropped or driven
at an irregular angle.
METHODS OF OPERATION
This Nailer is equipped with the push lever and does not
operate unless the push lever is depressed.
There are two methods of operation to drive nails with this
Nailer.
They are:
(1) Intermittent operation (Trigger fire):
(2) Continuous operation (Push lever fire):
1. Intermittent operation (Trigger fire)
Use the FULL SEQUENTIAL ACTUATION
MECHANISM setting.
WARNING
● For intermittent operation, Set the nailing
operation switch to FULL SEQUENTIAL
ACTUATION MECHANISM (Nailing operation
indicator is light in blue.) (i.e. Set to SINGLE
ACTUATION MECHANISM.)
● To avoid double firing or accidental firing due to
recoil.
1) Set to FULL SEQUENTIAL ACTUATION
MECHANISM.
2) Pull the trigger rapidly and firmly.
English
19
2024/07/31 17:15:40
Publicité
