Publicité
2. Insert the battery to the battery charger.
Firmly Insert the battery into the battery charger as
shown in the figure.
Battery
Pilot lamp
3. Charging
When inserting a battery in the charger, the pilot lamp
will light up continuously in red.
When the battery becomes fully recharged, the pilot
lamp will blink in red. (See Table 2)
(1) Lamp indication
The indications of the pilot lamp will be as shown in
Table 2, according to the condition of the battery
charger or the battery.
Table 2: Indications of the pilot lamp
ON/OFF at 0.5 sec. intervals
Lights continuously
Lights for 1 sec. at intervals of
0.5 sec.
ON/OFF at 0.1 sec. intervals
NOTE
*1 If the red lamp continues to blink even after the
charger has been attached, check to confirm that the
battery has been fully inserted.
*2 Battery overheated. Unable to charge.
Although charging will start once the battery has
cooled down even when left in situ, the best practice
is to remove the battery and allow it to cool down in a
shaded, well-ventilated location before charging.
*3 Malfunction in the battery or the charger
–
Fully insert the battery.
–
Check to confirm that no foreign matter is stuck
to the battery mount or terminals. If there are no
foreign objects, it is probable that the battery or
NV1845DA_C99751761_409_NA
Stylesheet: NA Version: 2024.7.4
○ If the pilot lamp does not blink in red even though the
○ When the battery charger has been continuosly used,
Guide rail
(2) Regarding the temperature of the rechargeable
Rechargeable
batteries
BSL1820M
1
Before charging *
(3) Regarding recharging time (At 68°F (20°C))
or
Table 4: Charging time
Charging complete
Battery
While charging
BSL1820M
NOTE
Overheat standby *
2
○ The recharging time may vary according to the
○ If charging takes a long time
Charging impossible *
3
4. Disconnect battery charger from the receptacle.
charger is malfunctioning. Take it to your
authorized Service Center.
charger cord is connected to the power, it indicates
that the protection circuit of the charger may be
activated.
Remove the cord or plug from the power and then
connect it again after 5 minutes or so. If this does not
cause the pilot lamp to blink in red, please take the
charger to the metabo HPT Authorized Service
Center.
the battery charger will be heated, thus constituting
the cause of the failures. Once the charging has been
completed, give 15 minutes rest until the next
charging.
battery.
Table 3
Temperatures at which the battery
can be recharged
32°F–122°F
(0°C–50°C)
Charger: UC18YFSL
ambient temperature.
–
Charging will take longer at extremely low
ambient temperatures. Charge the battery in a
warm location (such as indoors).
–
Do not block the air vent. Otherwise the interior
will overheat, reducing the charger's
performance.
–
If the cooling fan is not operating, contact a
metabo HPT Authorized Service Center for
repairs.
CAUTION
Do not pull the plug out of the receptacle by
pulling on the cord.
English
Approx. 30 min
13
2024/07/31 17:15:40
Publicité
