Publicité
English
This Nailer has a lock mechanism to prevent the nails from
being fired.
Set the lock lever at the
Slide the lock lever to the
be used, and to the
position when it is not in use.
position
position
Trigger
TESTING THE NAILER
DANGER
Operators and others in work area MUST wear
safety glasses with side shields which conforms
to ANSI Z87.1 specifications.
WARNING
Never use Nailer unless push lever is operating
properly.
CAUTION
Use caution not to throw the push lever tip onto
wood.
Before actually beginning the nailing work, test the Nailer
by using the checklist below. Conduct the tests in the
following order.
16
NV1845DA_C99751761_409_NA
Stylesheet: NA Version: 2024.7.4
position to lock the trigger.
position when the Nailer is to
Lock lever
If abnormal operation occurs, stop using the Nailer and
contact a metabo HPT authorized service center
immediately.
1. REMOVE ALL NAILS AND BATTERY FROM
NAILER.
–
ALL SCREWS MUST BE TIGHTENED.
–
THE PUSH LEVER AND TRIGGER MUST MOVE
SMOOTHLY.
Trigger
Push lever
2. Installing the battery.
Do not operate the push lever or trigger while
installing the battery.
3. Turn on the Power switch.
Turn on the Power switch by push and hold on Power
switch more than 1 second.
Make sure the power indicator is lighting in green, and
nailing operation indicator is lighting in blue.
(FULL SEQUENTIAL ACTUATION MECHANISM)
NOTE
Do not press the push lever and/or pull the trigger
during the process of turning the power switch ON.
Doing so will prevent the power switch from turning
ON.
[Auto power off]
When the power is turned on but the Nailer is not
used for 30 minutes, the Nailer is automatically
turned off. To turn on again, press the power switch.
WARNING
Never leave the Nailer with the power on. This
could result in an accident.
Nailing operation indicator
Lighting (Blue):
FULL SEQUENTIAL ACTUATION MECHANISM
Blinking (Blue):
CONTACT ACTUATION MECHANISM
2024/07/31 17:15:40
Publicité
