Publicité
English
(2) Move the nail holder up and down to align the plate of
the nail holder with a mark on the magazine in
accordance with the length of the nails being used.
(3) Turn the nail holder 90 degrees clockwise until you
hear "click".
Nail holder
For 7/8", 1" and 1-1/4"
(22 mm, 25 mm, 32 mm)
For 1-1/2" (38 mm)
For 1-3/4" (45 mm)
NOTE
Before loading the nails in the magazine, position the
nail holder according to the length of the nail. If the
nail holder position is not adjusted, the nail jam. If the
cover is forcibly closed without adjusting the position
of the nail holder, the nail holder may be damaged.
3. Place the nail coil into the magazine.
Uncoil enough nails to reach the driving hole.
First nail
Driving Hole
4. Insert the first nail into the driving hole and the second
nail between the two pawls of the feeder.
Fit the nail heads in the guide slot.
Pulling the nails to the right.
18
NV1845DA_C99751761_409_NA
Stylesheet: NA Version: 2024.7.4
2
Magazine
1
3
Plate
Magazine
Nail
Second nail
First nail
Nail guide
Driving Hole
NOTE
Be careful not to deform the collated wires and not to
disengage the nails with the guide surface.
Otherwise, the nail guide will not close correctly.
5. Close the magazine cover, then close the nail guide.
6. Lock the knob completely.
WARNING
Completely Close the nail guide and do not open
it during operation.
If nailing is attempted when the nail guide is
open, nails will not be driven into the timber, and
there is a risk of dangerous discharge.
Knob
2
Nail guide
The Nailer is now ready to operate.
NAILER OPERATION
Read section titled "SAFETY" (pages 2–9).
Guide slot
Guide surface
Feeder
Pawl
1
Magazine cover
2024/07/31 17:15:40
Publicité
