Publicité
Descaling
Descaling procedure
Descaling needs to be carried out when the machine requires it.
Use only the Gaggia descaling solution designed to guarantee high quality
performances of the machine. The use of different products could damage the
machine and leave residue in the water. Failure to descale the machine will void the
warranty.
1
Press CLEAN/SET
Select " DESCALING " and after confirming with "
-
CLEAN
DESCALING
BREW GROUP CLEAN
START/STOP
QUICK MILK CLEAN
DEEP MILK CLEAN
2
Remove the drip tray and the coffee pucks container, empty and place them all
back into the machine.
3
Remove the water tank and empty it. Remove the INTENZA+ filter, if in place.
4
Pour the entire bottle of Gaggia descaling solution into the water tank and fill
the tank with water up to the CALC CLEAN level. Place it back into the machine.
5
Fill the milk carafe halfway with water and insert it in the machine.
6
Place a large container (1.5l) under the milk and coffee dispensing spouts.
7
Follow the instructions shown on the display to launch the descaling
procedure. This procedure lasts approximately 25 minutes and consists of
a descaling cycle and a rinse cycle, carried out with dispensing at regular
intervals.
8
Once the descaling cycle is over, rinse the water tank, milk carafe and water
circuit, following the instructions shown on the display.
9
Position the INTENZA+ filter back again into the water tank.
Note: it is possible to pause and resume the procedure at any time by pressing the
START/STOP
Warning: when the descaling procedure is active, the brew group cannot be
removed. Wait for the descaling process to end, then remove the brew group.
and select the " CLEAN " button shown on the display.
clean/setting
button to start.
button.
START/STOP
English
" press the START/STOP
31
Publicité
