Publicité
How to check that your d-control works correctly
You can check anytime whether your set works correctly. Before the check, make sure that the
receiving collar is turned off.
Connect the leads of the testing discharge lamp to both
contact points (loosen up the contact points, insert the wires
of the lamp under them so that they can be firmly held and
then retighten the contact points).
Turn on your remote controller and receiver.
Press down the button for sending a stimulation impulse. The
testing discharge lamp will indicate the receipt of the signal
by a blink. The alteration of the intensity of the pulses
according to options 1 to 4 will be indicated by a weaker or
stronger light of the lamp.
At this moment, the stimulation impulse is only indicated by
the light of the test discharge lamp, i.e. the contact points do
not emit any stimulation impulse.
For the best results
Training commands, you are sending to your dog, are transmitted from the transmitting unit to
the collar equipped with the receiver by radio waves. The propagation of radio waves is influenced
by a series of factors and under normal conditions the range of this unit is approximately
200 metres (depending on geographic conditions and surroundings).
If you want to get the best results with your unit, adhere to the following instructions:
To reach the best range for your communication, hold your remote controller in your hand and
do not cover its front part (the antenna is located there).
36
Figure indicating the test lamp
attached
Publicité
