Publicité
Turning ON/OFF
TURNING THE REMOTE CONTROLLER ON/OFF
Turning on: Press down for 1 second the ON/OFF button
Turning on is indicated by a sound signal and by a flashing green LED.
Turning off: Again, press down for 1 second the ON/OFF button
indicated by a sound signal and the green LED stops flashing.
CAUTION: To save the service life of the battery, the transmitter will be automatically turned
off after 120 minutes of inactivity.
SWITCHING THE RECEIVER ON/OFF
To turn the receiver ON/OFF (or for programming the transmitter with the receiver) is used a
magnetic switch, marked with the red target on the receiver. The receiver is activated when the
magnet in bottom of the transmitter, is enclosed to the red target on the receiver.
Switching ON: Move the red target of the receiver towards the bottom of the transmitter for
1 second (see the Fig.). The red LED indicator of the receiver
will lit up, afterwards the green LED indicator will start
blinking. The receiver is prepared for use.
Switching OFF: When switching OFF, follow the same steps
as when switching ON. Move the red target of the receiver
towards the bottom of the transmitter - the green LED
indicator of the receiver will lit up, afterwards the red LED
indicator will lit up.
To enhance the service life of the battery, it is necessary to turn
off the receiver always after training is finished. If the receiver is
not used for a longer period of time, we recommend you to
remove the battery from it.
on the remote controller.
. Switching off is
The situation when the receiver is
turned on/off and the transmitter
is being matched with the receiver
33
Publicité
