Publicité
Reprogramming of your receiver
The receiver can be programmed repeatedly without restraint either using the same remote
controller or with another (see the section Programming (pairing) of the transmitter and the
receiver).
TIP: It is possible to program an unlimited number of trasmitters to one receiver, which is
possible to use for common training of several dogs. It is possible to record two transmitters
into one receiver, which the instructor can use, for instance, for a potential correction of the
dog training.
How to use the remote controller
The Dogtrace d-control easy remote controller is designed for interaction with one receiver.
Button
– sound signal
When you press down the sound signal button, you will be able to send the sound signal to your
receiver within a great distance. There is no time limit for this function: The buzzer will sound for
as long as you are holding the pressed down button and the green LED on your receiver will be
permanently lit.
Buttons
to
By pressing down this button, you will send your dog an alert in the form of stimulation impulse
transmitted by the two contact points located in the receiver collar, being generated all the time
you are holding the pressed down button, however, restricted for 8 seconds at the most.
The transmission will be indicated by the red LED on your receiver that will be lit as long as you
are pressing down the buttons for stimulation impulse.
Level 1: very weak impulse
Level 4: strong impulse
Level 2: weak impulse
Level 5: very strong impulse
Level 3: medium strong impulse
Level 6: the strongest impulse
35
Publicité
