Publicité
IMPORTANT: When turning the receiver ON hold the red target of the receiver close to the red
target of the transmitter for about 1 second. When the targets are close to each other for
longer than 5 seconds the receiver will switch to the pairing (programming) mode of the
transmitter with the receiver. This programming mode is indicated by alternate flashing of the
red and green LED indicator. If this occurs, follow the chapter Programming (pairing) the
transmitter and the receiver.
Programming (pairing) of the transmitter and the receiver
Each transmitter has its own RF operational code. The pairing needs to be done to make the
receiver and transmitter operate together. When you receive a new set the pairing is done by
manufacturer. The pairing is done, when you need to use different transmitter or receiver (for
example when bought a new one).
IMPORTANT: Before programming is started (before using your receiver for the first time or
before code rewriting) make sure that no one else uses his/her d-control or another product
made by Dogtrace in your neighbourhood – your receiver might randomly receive the code
from another remote controller and set itself to it. If this happens, program your receiver once
again, using your remote controller.
Turn on your transmitter.
The receiver has to be turned OFF.
Touch the lower part of your remote controller to the target on your receiver (see the photo on
page 33). The green LED will be permanently lit and after some 6 seconds, it will switch to the
programming mode, indicated by permanent flashing of the red LED.
Now take your transmitter away and press down the sound signal button
controller. The codes will be matched in this step and your receiver will produce a sound signal.
34
on your remote
Publicité
