Rear Panel; Monitor Display - Sony UP-55MD Mode D'emploi

Rear Panel

A - AC IN connector (12, 13, 14)
Use a proper power cord for your local power
supply (not supplied).
Refer to "Warning on power connection" on page 6
and "Warning on power connection for medical
use" on page 6.
B
REMOTE 1 connector (special mini jack)
(14)
Used to connect an RM-5500 Remote Control Unit
(not supplied) to be used as a wired remote control
unit.
C
REMOTE 2 connector (stereo mini jack) (14)
Used to connect an RM-91 Remote Control Unit
(not supplied) or an FS-24 Foot Switch (not
supplied).
D RS-232C connector (14)
Used to connect a computer to control the printer.
For details, contact your nearest Sony dealer.
E Dip switches
Used to set the video signal system to select either
NTSC or PAL video system.
When the dip switch 1 is set to the lower position,
the NTSC video system is selected.
When the dip switch 1 is set to the upper position,
the PAL video system is selected.
Note
To set the dip switch, turn the power off once, then
change the setting. If you change the setting with
the power on, this mode will not be switched.
10
Location and Function of Parts and Controls
F
OUTPUT (RGB/YCbCr/SYNC) connectors
(12)
Used to connect the video equipment with RGB/
YCbCr input connectors.
G
INPUT (RGB/YCbCr/SYNC) connectors/
75Ω termination ON/OFF switch (12)
INPUT connector: Used to connect the video
equipment with RGB/YCbCr output connectors.
75Ω ON/OFF switch: Normally set this switch to
ON. Set it to OFF if the input signal should drop
when you connect additional equipment to the
video equipment.
H S-VIDEO IN/S-VIDEO OUT (S-video signal
input/S-video signal output) connectors (12, 13)
S-VIDEO IN connector: Used to connect to the
video equipment with Y/C separated output
connector.
S-VIDEO OUT connector: Used to connect to the
video equipment with Y/C separated INPUT
connector.
I VIDEO IN/VIDEO OUT connectors (Composite
video signal input/composite video signal
output)//75Ω termination ON/OFF switch (12,
13)
VIDEO IN connector: Used to connect to the video
equipment with a composite video signal output
connector.
VIDEO OUT connector: Used to connect to the
video equipment with a composite video signal
input connector.
75Ω ON/OFF switch: Normally set this switch to
ON. Set it to OFF if the input signal should drop
when you connect additional equipment to the
video equipment.
J
Equipotential ground terminal connector
Used to connect to the equipotential plug to bring
the various parts of a system to the same potential.
Refer to "Important safeguards/notices for use in
the medical environments" on page 2.

Monitor Display

When the printer is connected to the video monitor and
you first turn on the printer, the following regular screen
message appears.
When the MENU button is pressed, the menu screen
displayed.