Publicité
of rotation.
13.5.6 Reinstall the two bolts and lock washers that secure the blade to the
trowel arm. Tighten the bolts securely.
13.5.7 Repeat steps for all remaining blades.
13.6 Installing Pans onto Finisher Blades
WARNING
Lifting/Crush Hazard.
Do NOT lift the trowel with the pans attached.
ALWAYS install the pans on the work area or an area that is next
to/level with the work area.
DO NOT lift the trowel when the pans are attached.
13.6.1 Lift the trowel just enough to slide the pan under the blades. With
the blades adjacent to the Z-clips, lower the finisher onto the pan.
13.6.2 Rotate the blades into position under the Z-clips. Ensure that the
blades are rotated in the direction of travel when the machine is in
operation. Or, use the engine to rotate the blades into position.
13.6.3 Attach the blade tie-downs to the far side of the Z-clip brackets with
tie-down knobs.
13.6.4 Before the machine is put back into operation, check to make sure
that the blade edges are secured under the Z-clips.
13.6.5 Before the machine is put back into operation, check to make sure
that the tie-downs are secured firmly over the edges of the blade.
13.7 Spider Box Removal
13.7.1 Once it is determined that an adjustment is required, remove the
spider assembly from the gearbox shaft as follows:
13.7.2 Remove the zerk fitting and allen head screw designated by the
letter "S".
13.7.3 On the opposite side of the spider block, there is another zerk fitting
and allen head screw. Remove both of these components.
- 30 -
Publicité
