Publicité
Remove the auxiliary lifting tube located on top of the main handle. Insert
the tube into the socket located on the opposite side of the gearbox from
the handle. Make sure that the hole in the tube engages with the pin in the
socket. With one person lifting from the main handle, and another lifting
from the auxiliary lifting tube, pick up the machine to move onto a slab.
WARNING
The trowel must be stabilized by the person carrying the operator's
handle. If it is not stabilized properly the handle may swing around
and flip the trowel, thus causing damage to the trowel and bodily
injury.
8.2 Lifting Bale
The lift bale is optional on new trowels. It provides an optimal lift point for
moving the trowel. Lift bales or forklift can be used to lift a trowel up onto a
building with a crane.
Using a crane to move a machine with a lift bale is highly recommended,
and is perfectly safe for the machine. Extra care should be taken when
lifting the machine off the ground, though. Serious damage to the machine
or personal injury could be caused by dropping a trowel.
8.2 Lifting Bale Continued
This section is intended to assist the operator with the initial start-up of the
walk-behind trowel. It is extremely important that this section be read
carefully before attempting to use the trowel in the field.
DO NOT use your trowel until this section is thoroughly understood.
WARNING
DO NOT attempt to operate the trowel until the Safety, General
Information, and Inspection sections of this manual have been read
- 20 -
Publicité
