Publicité
3.1 Pulling the safe key will put a quick stop to the machine which will beep. Before restart, please put the
yellow magnet to the original place.
3.2 Press START/STOP, the machine will stop working
IMPORTANT SAFETY INSTRUCTION
The machine is for home use
1.
The voltage for the machine is 220V.
2.
Before operating the machine, please do 10-minute warm-up and wear clothes and shoes that are
3.
suitable for sports
Do not stand on the motorized treadmill when you adjust, test or start the motorized treadmill.
4.
Be careful when you get on or off the machine. Before starting the machine, please grab the handlebars
5.
and place your feet on the side rails (not the running belt). After starting the machine, stand on the belt with
the machine operating at the lowest speed. Then increase the speed gradually. Before getting off the
machine, please decrease the speed to the lowest level in case of any danger.
When operating, press the safety at any time, the motor will stop working and the controller will give
6.
warnings.
Children should be supervised by adults when they play on or beside the machine.
7.
The motorized treadmill should be protected from sunshine, damp and dirt. All the parts shall be cleaned
8.
often.
When the machine is free from using for a long time, please don't place any objects or stand on the
machine.
CARE AND MAINTENANCE
For cleaning the running belt use a vacuum cleaner. If the belt is really dirty, please use a wet cloth. Do not
use any cleanser. When cleaning, use only a moist cloth and avoid harsh cleaning agents. Ensure that no
moisture comes into the computer. Components that come into contact with perspiration,need cleaning only
with a damp cloth.
1. Lubrication
The treadmills have already been spread with "Silicone Oil" in advance before leaving the manufacturing
plant. Silicone oil is without volatility and has gradually permeated through the running belt. There will be
no need to re-spread the oil in normal circumstances.
To maintain the running belt, we have included a small bottle of "Silicone Oil". "Silicone
Oil" may be re-spread once the resistance has been increased and the running belt starts
rubbing against the running deck. To hold open the running belt from two sides, apply the
silicone oil with an even motion on the center of the running deck. Allow the silicone oil to
'set' for one minute before using the treadmill.
Attention: Only use "Silicone Oil" lubricants for this equipment. In addition, do not add
any other oil ingredient; otherwise the treadmill will be damaged. Do not over-lubricate
the walking board. Excess lubricant should be wiped off with a clean towel.
- 26 -
Publicité
