Application connection
Copy the link here under to your browser (Edge, Firefox, Chrome, Safari etc)
https://cloud.carefitness.com/index.php/s/E2WD22KMNBQzERL
And Follow the detailed instruction
8. ERROR SINGNAL
Code
Problem
Display did not receive
ER1
the signal in 30 seconds
ER3
Over Voltage
ER4
Over Power Current
ER5/ER14
Overload
ER6
Motor not working
Motor Control Board did
ER7
not receive the signal
IC BROKEN OR
ER8
FOLDED FUNCTION
ER13
SAFE
Safety Protect
1. PREPARATION BEFORE START
1.1 Plug in the power cord and press the power key at the down front part of the machine. If the machine is
not operated or moved for a long time, please turn off the power.
1.2 Nip the safe key on the clothes and put the switch of magnet into the computer. If the safety magnet is
not put into the assigned location, then the machine will not work.
2. START
2.1 Press START/STOP, the machine begins to work with starting speed 1.0KM/h
2.2 Press SPEED can control the speed, with one press 0.1 KM/h will be increased or decreased. Press the
key without stop can get to the speed you want.
3. TWO WAYS TO STOP THE MACHINE
Possible Reason
Main reason: Cable connection
Motor interference
MCU connection or component broken
Input Voltage over 265v
MCU IC2 broken
Motor Belt too tight
IGBT Broken
Running Deck resistance too high
User over Maximum User Weight
Data setting wrong
Motor Cable not connected
IGBT Broken
Cable connection or open circuit
problem
MCB Connection broken
Motor interference
IC BROKEN OR FOLDED FUNCTION
MCU IGBT ic broken
Safety Key
Computer Diode broken
Safety Key sensor broken
OPERATION INSTRUCTION
- 25 -
Solution
Check or replace the Cables
Add the Degauss Ring on the Motor
Cable
Replace the MCU
Adjust the Voltage to 220v
Replace MCU or the IC2
Adjust the Motor Belt
Replace the MCB or IGBT
Add lubricant (Silicon Oil / Spray)
Reduce users weight
Re-set the data
Check the Motor Cable or replace
the Motor
Replace MCU or IGBT
Replace the Connecting Cable
Replace the MCU
Add the Degauss Ring on the Motor
Cable
replace the MCU(motor controller
board) Or Check if the machine was
folded
replace the IC or change the whole
MCU
Safety Key not fitted
Replace Computer Diode
Replace sensor