Publicité
COUNTER MODES
The counter can be set to one of three following modes: normal
tape counter, time counter for displaying the elapsed recording or
playback time, or remaining time counter for displaying the remain-
ing tape time.
COUNTER MODE button
By pressing this button repeatedly, the following three modes are
called in succession:
Tape counter
yeogn
Remaining time
y
counter
Time counter
5.5 GF ema
Ju.ee
TAPE COUNTER
The counter reading will change as the tape runs. By taking a note
of the counter readings and the contents during recording or play-
back, desired selections or unrecorded portions on the tape can be
easily located at a later date.
TIME COUNTER
®
Displays the elapsed time during recording or playback. The time
counter is automatically activated when the unit is set to record-
ing or playback.
® The time counter displays only the recording or playback dura-
tion. It disappears when fast forward, rewind or music search
is performed, and is replaced by the tape counter. When record-
ing or playback is restarted, the time counter appears again.
REMAINING TIME COUNTER
Displays the remaining time of the tape during recording or playback.
1. Set to remaining time counter mode
by pressing the
COUNTER
MODE button.
2. Press the COUNTER
RESET/TAPE
CAPA
button.
The counter display changes to the tape capacity display. By
pressing the selector repeatedly, the following settings are called
in sequence.
ren
L Ou
a
(60-minute tape)
ar
Hi i
LOUL
MBL
oe
tape
wae
tape
with large hubs)
with large hubs)
pee
~ cre
L
a!
Li
(90-minute tape)
Set the tape capacity according to the length of the tape in use.
3. Set to playback or recording mode.
Five to seven seconds after the tape starts running, the remaining
time for the tape is displayed.
NOTES:
°
The remaining time can be indicated only for the four types of
cassettes that can be selected with the COUNTER RESET/TAPE
CAPA button.
When using tapes of different lengths, set the
selector as follows to obtain a close enough estimation of the
remaining time.
Up to C-60, standard hub tapes
Up to C-60, large hub tapes
.........
. C-46L position
Up to C-90, standard hub tapes ....
C-90 position
Up to C-90, large hub tapes
........cccccce eee C-80L position
¢
For commonly sold pre-recorded tapes the remaining time may
not be displayed correctly.
©
The actual remaining time may differ from the remaining time
indication depending on the tape used. Also, since most tapes
are slightly longer than the playing time indicated on the label,
the remaining time indication ''OO00"' may be reached before
the actual end of the tape.
*
Once the remaining counter has been displayed, even if the coun-
ter mode is changed, the remaining time can be checked again
by simply selecting the remaining counter mode.
C-60 position
NOTE:
46-minute and 80-minute tapes can be purchased with two differ-
ent hub sizes: standard hub and large hub. Tapes with large hubs
are marked with an "L'', such as C46L and C8OL.
Tapes with a hub diameter of 27 mm are referred to as large hub
tapes.
Please note that with hub diameters of more than 27 mm the tape
remaining time indication will not be corred.
=
ata hub
Large hub
16
<RRE1057>
En
Publicité
