Dremel DD12V Consignes D'utilisation/De Sécurité page 33

Problem
Laser Level will not stick to
surface.
1600A034F4 AA Dremel DD12V OSI 20240729.indd 33 1600A034F4 AA Dremel DD12V OSI 20240729.indd 33
Troubleshooting
Cause
Mounting Putty 29 no lon-
ger sticky.
Surface is dirty.
Corrective Action
Replace Mounting Putty
29 as outlined in "Fasten-
ing the Laser Level with
Mounting Putty" on page
28. Additional Mounting
Putty can be purchased at a
Dremel Service Center.
Clean and dry wall.
7/29/2024 5:00:24 PM 7/29/2024 5:00:24 PM
33