Publicité
Forward/Reversing Lever and
Trigger Lock
(Fig. 9, Fig. 10, Fig. 11)
to help prevent accidental starts and acci-
dental discharge.
Do not change direction of
rotation
comes to a complete stop. Shifting during
rotation of the Hex Drive can cause damage
to the tool.
Your tool is equipped with a Forward/Re-
versing Lever and Trigger Lock 3 located
above the Variable Speed Trigger Switch 1.
This lever was designed for changing the di-
rection of rotation of the bit, and for locking
Fig. 9
1600A034F4 AA Dremel DD12V OSI 20240729.indd 17
1600A034F4 AA Dremel DD12V OSI 20240729.indd 17
Drill/Driver Operation
After tool use, lock the
trigger in "OFF" position
until
the
3
3
1 1
the Variable Speed Trigger Switch 1 in an
"OFF" position.
For forward rotation, (with Hex Drive point-
ed away from you) move the Forward/Re-
versing Lever and Trigger Lock 3 to the far
left
.
For reverse rotation, move the Forward/Re-
versing Lever and Trigger Lock 3 to the far
right
.
tool
To activate the trigger lock, move the For-
ward/Reversing Lever and Trigger Lock 3 to
the center off position
Only adjust the Forward/Reversing Lever
and Trigger Lock 3 while the tool is off.
Fig. 10
3 3
1 1
.
17
7/29/2024 5:00:19 PM
7/29/2024 5:00:19 PM
Publicité
