Publicité
Use these tools only as intended. Unintended use may result in personal
injury and property damage.
This is a hand-held, cordless driver with drill
functionality, a built-in stud finder, and re-
movable laser level.
Driver/Drill
The power tool is intended for driving and
loosening screws; drilling into wood, mild
metal, drywall, and plastic; and for light
duty wire brushing.
This Driver/Drill is NOT intended for use
with accessories which require auxiliary
handles such as, but not limited to, spade
bits, auger bits, hole saws, self-feed bits and
forstner bits. This Driver/Drill is NOT intend-
ed for use with drill bits exceeding 6 inches
in length.
Stud Finder
The detector is intended for the edge detec-
tion of metal studs, wood studs, and joists
through drywall on walls and ceilings. The
stud finder is exclusively for operation in-
doors.
The Stud Finder is not intended for sensing
the center of studs.
The Stud Finder is not intended for detec-
tion through:
• Brick, concrete, and other masonry
surfaces
• Glass, ceramic tile, granite, marble,
slate, and other hard surfaces or dense
materials
• Bathroom inserts of any material such as
shower enclosures, tubs, and sinks.
• Carpeting and carpet padding
• Metallic wallpaper
• Lath and plaster walls
• Walls with metallic membranes, includ-
ing foil backed insulation board or foil-
covered insulation
• Wood surfaces such as plywood, shi-
plap, wainscotting, beadboard, peg-
board
• Decorative wall paneling with metallic
layer
10
1600A034F4 AA Dremel DD12V OSI 20240729.indd 10
1600A034F4 AA Dremel DD12V OSI 20240729.indd 10
Intended Use
• Acoustically insulated walls and ceilings
• Exterior walls
• Wet surfaces including freshly painted
• Surface materials thicker than 5/8"
Laser Level
The Laser Level is intended for indicating
horizontal, vertical, and straight lines at
various orientations. The laser level is ex-
clusively for operation indoors and on non-
reflective surfaces.
SAVE THESE INSTRUCTIONS
walls and freshly adhered wall coatings
such as wallpaper
7/29/2024 5:00:17 PM
7/29/2024 5:00:17 PM
Publicité
