General Safety Guidelines; Your Ed-1.2 Pedelec And His Components - Pedelec ED-1.2 Manuel De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Your ED-1.2 Pedelec and his components

Drive battery
Status display of the drive battery
Lock of the drive battery
Motor control (electronic)
Charging input bushing
Crank with rotary sensor
Hub motor
Motor plug cover
Handlebars: operational
controls (panel)

General safety guidelines

Roadworthiness
According to the regulations set forth in the
StVZO, Pedelecs as well as bicycles must meet
the following statutory minimum requirements:
• Two brakes which function properly and
independent of each other.
• A bell with a clear sound
• Dynamo (nominal voltage 6V and nominal
output 3W) bearing the test symbol "K - - - ".
ED-1.2 Pedelec with Lithium-ion battery
• At the front, a lamp emitting white light.
• A white-reflecting front reflector.
• A taillight emitting red light, affixed higher
than 25 cm above the roadway surface.
• A red rear reflector, affixed no higher than
60 cm above the roadway surface.
• A large red rear reflector bearing the letter Z.
• Pedals equipped with yellow rear reflectors
emitting to the front and rear, bearing the test
symbol "K - - - ".
• In the front and rear wheel, two yellow-
emitting reflectors (or white-reflective side
strips at the front and rear, on the tyres and/
or rims).
GB
27

Publicité

Table des Matières
loading

Table des Matières