Publicité
3. See Figure 1. Remove the nut securing the neutral
ground wire andattach the bonded jumper wire. install
the nut.
1
4. install the alternator cover.
IMPORTANT: Apply a new "NEUTRAL UNBONDED"
Label over the "NEUTRAL BONDED TO
FRAME" label on the front of the control
panel.
HIGH ALTITUDE OPERATION
Engine power is reduced the higher it is operated above
sea level. Output will be reduced approximately 3.5% for
every 1000 feet of increased altitude from sea level.
High altitude adjustment is required for operation at
altitudes over 2000 ft. (762 m). Operation without this
adjustment will cause decreased performance, increased
fuel consumption, and increased emissions.
Do not operate the generator at altitudes below 2,000
ft. (762 m) with the high altitude kit installed. Engine
damage may occur.
High Altitude Carburetor Kit Part# 518904
REMOTE START
Confirm that the area around the generator is clear
before remote starting the generator.
The remote start key fob included with the generator
should
be attached to the recoil handle or control
panel. If the unit was shipped without a key fob, contact
customer service.
The generator can be started remotely from up to 99 feet
(30 meter) using the remote start key fob.
Note: As the batteries in the remote start key fob drain,
operational distance will decrease.
NOTICE
OPERATION
PAIRING THE REMOTE START
Remote replacement batteries: (2) CR2016
Remote replacement: Part# 100714A
If the remote start key fob is replaced or needs re-paired to
the generator, follow this procedure:
1. See Figure 2. Turn the generator battery switch to the
ON position. The power indicator light will illuminate.
2
2. See Figure 3. Press and hold the red pairing button on
the back of the control panel until the START/STOP button
illuminates.
3
3. See Figure 4. Press and hold the STOP button on the
key fob until the START/STOP
turns OFF. Release the button. The START/STOP
button will illuminate after the button is released.
4
4. Press and hold the START button on the key fob until the
START/STOP button illumination turns OFF. Release
the button. The START/STOP button will illuminate after
the button is released.
5. Press the pairing button on the side of the control panel
until the START/STOP button illumination turns OFF.
Release the button.
6. Turn the generator battery switch to the OFF position.
The remote is now paired.
button
illumination
| 15
Publicité
