Function Test; Warnings; Technical Data - Truma S 5004 E Instructions De Montage

Function test

After installation, the tightness of the gas supply line
must be tested according to the pressure drop method.
Also, a function test needs to be carried out (in Germany e.g.
acc. to TRGI – Technical Rules for Gas Installation / DVGW
work sheet G 600 Annex 5)
Version with lighting
Each time the 12 V voltage supply is produced, the sensor
electronics calibrate the lighting. This can take several sec-
onds. Do not touch the cover during calibration.
Then check all the functions of the unit in accordance with the
instructions for use.
The operating instructions must be handed to the owner of
the vehicle.

Warnings

The stickers enclosed with the unit must be attached to the
vehicle in a visible place for all users by the installer or vehicle
owner! Any missing stickers can be ordered from Truma.

Technical data

(established according to EN 613 or Truma test conditions)
S 5004 E
Gas type
Natural gas
Operating pressure
20 – 25 mbar (see type plate)
Rated thermal output
5000 W
Connection value
0.57 m³/h
Additional information according to EN 613
Q = 5.4 kW (Hi); C ; I
51 2E+
n
NOx class 4
Countries of destination
DE, DK, ES, GB, IT, AT, FR
Operating voltage
1.5 V (automatic ignition device with battery compartment)
Current draw
225 mW (ignite)
Weight
approx. 17.5 kg (without fan)
CE product ID number
CE-0085CM0288
The right to effect technical modifications is reserved!
S 5004 E NL
Gas type
Natural gas
Operating pressure
25 mbar (see type plate)
Rated thermal output
4400 W
Connection value
0.6 m³/h
Additional information according to EN 613
Q = 4.4 kW (Hi); C ; I
51 2L
n
NOx class 4
Countries of destination
NL
Operating voltage
1.5 V (automatic ignition device with battery compartment)
Current draw
225 mW (ignite)
Weight
approx. 17.5 kg (without fan)
CE product ID number
CE-0085CM0288
The right to effect technical modifications is reserved!
17