Publicité
To remove stubborn dirt, you can remove the attachment A with the cutting
■
blades 4 from the blender jug 3:
Fig. 3
1) Remove the blender 3 from the motor block 6. For better stability, remove
the lid 2 by turning it anticlockwise towards the
until you can pull it off upwards.
2) Turn the appliance upside down and turn the attachment A anticlockwise so
that it can be detached from the jug of the blender 3 (see Fig. 3).
3) Clean both parts in a mild soap solution or in the dishwasher.
NOTE
If necessary, you can remove the sealing ring B from the attachment A. Pull
the sealing ring B carefully out of the attachment A and clean it in a mild
soap solution. Rinse it off afterwards with fresh water.
4) Dry all parts thoroughly before reassembling them.
5) Replace the attachment A with the cutting blades 4 onto the blender jug
3 and turn it clockwise. Make sure the sealing ring B is inserted correctly.
■
14
│
GB │ IE
A
B
position (see Fig. 1)
SSTMC 600 A1
Publicité
