Publicité
C – Installing and removing the side racks
EN
Rack 4
Rack 3
Rack 2
Rack 1
7. QUICK TROUBLESHOOTING GUIDE
In each emergency situation, you need to:
Set the cooking hob's dials to the "Off" position.
Unplug the appliance from the power source.
Contact the after-sales service.
Minor malfunctions can be resolved by users using the table below.
Before contacting customer services or the after-sales service, please refer to this table:
Possible breakdowns
The appliance is not
working properly
The burners aren't
working properly, no gas
Metallic noises can be
heard when the oven is
heating and cooling
Flames look unusual
Gas leak
For any other issues with your appliance: contact the After-Sales Service team.
To remove the side racks, press the clips indicated by the
arrows in the figure, and remove the bottom and then the top
side from the installation slot. To reinstall the racks, you just
need to repeat the same operation, but in reverse order.
Rack and baking tray positions
It is important that you properly position the rack in the oven.
Do not let the rack touch the rear panel of the oven.
The positions of the rack are shown in the figure. You can
also place a tray, or a drip tray (generally in the lower section)
for certain dishes or to catch cooking juices.
Causes and solutions
- Check that the power cable is properly plugged in.
- The fuse isn't working or has short-circuited. Check the fuses. If
the fuse has short-circuited, remove or replace it.
- There may have been a surge in the electrical network. Unplug the
power cable from the power socket and then plug it back in.
- There may not be any power. Check that the power supply is
working and the fuses are set properly. If necessary, reset the
fuses.
- Check that the gas inlet pipe is not pinched.
- Check that the gas inlet length is less than 2 m.
- Check that the gas supply is open.
- Check that the injector is not blocked.
- If you have a gas cylinder or a gas tank, check that it is not empty.
When metal parts heat up, they may make noises as they expand.
This is not a malfunction or a breakdown.
- Check that the burners and the injectors located under the burners
are all clean, and check the burner assembly.
- Check that there is enough gas left in your cylinder.
Shut off the gas supply and call the after-sales service.
22
Publicité
