Publicité
D – Installing the cooker's feet
EN
The cooker comes with four feet.
Place the cooker close to its final position.
Raise the cooker sufficiently to screw each foot underneath it.
Gently lower the cooker.
The feet are adjustable; simply screw or unscrew them to adjust the height of the cooker.
E – Connection
Your cooker is supplied to operate on the type of gas indicated on the serial plate.
Before connecting the appliance to the gas distribution network, check that the information on the
label found at the back of the cooker is compatible with your gas distribution network.
This cooker is delivered with natural gas, G20/G25.
However, if the cooker needs to be connected to butane (G30) or propane (G31) gas, another data
plate is available in the plastic bag containing the user notice. This data plate should be affixed to
the existing data plate, to indicate the type of gas set after conversion.
The flexible tubes or hoses must be within reach and visible along their entire length, and they
must be replaced before their use-by date (marked on the hose). New propane installations must
not be connected using a flexible hose mounted onto a stop end.
Only connect the appliance to the gas pipe or cylinder in accordance with the applicable
standards, after checking that the appliance is correctly set up for the type of gas supply used.
The connection must be made using a flexible gas hose that complies with the specifications
specified in current standards.
Connection must be made in accordance with EN 30-1-1, depending on the country of destination,
and with the specific regulations of each country. The gas connection is located at the rear of the
appliance (right-hand side). The cooker end is threaded (G1/2).
Appliance delivered with an NF ringed end + seal for using a soft tube with a collar for
LPG (liquefied petroleum gas) with a soft collared tube (Butane).
Pipe connection with mechanical connector.
WARNING: check that the hose is compliant and comes with both
seals. If the seals are not installed, there is a risk of explosion.
● We recommend using a standard flexible hose with a minimum
length of 1 m. The length should be chosen according to the position
of the gas tap.
● Connect one end of the flexible hose to the gas tap with the seal
correctly positioned. Before positioning the appliance between the
furniture units, connect the other end of the hose to your product
with the seal correctly positioned.
● Position the appliance, checking that the loop formed by the flexible
pipe extends into the underfloor space of the adjacent cabinet.
12
Flexible hose
Publicité
