Publicité
For re-assembly
1. Position the door so that it is facing the two hinges.
2. Lower the small hooks using a screwdriver, and adjust the door's two hinges to the same
position.
3. Check that the locking operation has been effectively carried out, and close the oven door.
B – Cleaning the oven glass
The inner glass panel can be removed for easier cleaning. This operation must only be carried out
when the cooker is cool.
• For dismantling:
- fully open the door and press the plastic latches on each side of the door (A).
- pull the upper section of the door frame towards you (B).
- lift the interior glass panel to remove it (C). Clean the glass panel and then dry it.
• For re-assembly:
- replace the glass panel with the upper section of the door frame by pushing it in towards
the inside of the oven. Make sure that the words "THERMAL REFLECTOR" are facing you.
(See Diagram below for the direction of the glass panel)
- press down on the latches to lock the glass panel in place and close the oven door.
Use a cleaning product for glass to clean the inside and outside of the oven door. Wipe down with
a damp cloth and then clean water, and dry using a soft, dry cloth.
WARNING: do not clean the oven door while the glass parts are still hot.
If this precaution hasn't been taken, the glass parts may shatter.
Do not use abrasive cleaning products or abrasive metal scourers to clean the oven's glass door,
as they may scratch the surface and cause the glass to shatter.
21
EN
Publicité
