4 plastic feet 1 or 2 hooks
EN
4. INSTALLATION
This appliance is not connected to an evacuation system for combustion products. It must be
installed and connected in accordance with current installation regulations. Particular attention
must be paid to ventilation requirements.
Before positioning the appliance, check that the local network conditions (gas type and pressure)
meet the appliance's requirements. The appliance's setting conditions are shown on the label
(or serial plate).
WARNING: the following instructions are provided for qualified installation technicians to
allow them to carry out installation, adjustment and technical maintenance operations correctly
and in compliance with the applicable standards.
IMPORTANT: 2 people are required to install this appliance.
A – Location
To guarantee correct operation of the appliance, the room in which the appliance is installed must
have upper and lower ventilation, as well as a window.
1 or 2 dowels
to stabilise
for screws
the appliance
GAS end
Injector sheet
fitting for
with butane gas
butane and
injectors attached
propane
10
1 or 2 plastic
seals