Control Panels / Cover; Attach Control Panels - Truma S 3004 Instructions De Montage

Control panels / cover

Attach control panels

The position of the knob socket (50) for the control knob (51 –
gas) is determined by the installation of the heater (right-hand
or left-hand installation). The control panels for the fans can
be installed in any free opening in the cover (62).
Push the knob socket (50) for the control knob (51 – gas) and
the control panel (22 – for TEB-3 fan) into the recesses (pay
attention to right-hand or left-hand installation). Attach con-
nector of fan to control panel.
Close off each free recess in the cover (62) with blank covers (63).
22
Figure 16
Version with lighting
Electrostatic charging can destroy the electronics.
Ensure that potential compensation is present before
touching the electronics.
The cover is supplied with pre-installed sensor electronics. At-
tach the connectors of the control panels to the sensor PCB in
any order. Secure the cables at the clamping brackets.
63
22
23
Figure 17
The lighting is supplied with power via the TEB-3 fan.
If the appliance S 3004 / S 5004 is operated without the
TEB-3 fan, a separate 12 V line (part no. 30090-38100) from
the fuse-protected on-board power supply must be routed
for the lighting (alternating current ripple <1.2 Vss).
63
51
0
1
5
4
2
3
50
62
51
63
50
0
1
5
4
2
3
62
Fit cover (62) to support (60) and engage. Ensure that the ca-
bles are routed without kinking and do not become trapped.
Fit control knob (51 – gas) to control rod (7) in such a way that
the mark points to the "0" position.
22
63
23
60
Figure 18
Figure B
Clip shield (65) into mica window recess of cover (left for
right-hand installation and right for left-hand installation).
51
62
63
50
0
1
5
4
2
3
7
23